fiveapi.blogg.se - Hypack output.dll

HYPACK OUTPUT.DLL PASSWORD

Get Mount Points – Use this button to obtain a list of available IBSS base stations for selection. Mount Point – Enter name of the correction stream to which you are connecting on the NTRIP Caster if known or select from the list using the Get Mount Points button.

HYPACK OUTPUT.DLL PASSWORD

Verify Password – Re-enter the password required to log on to the server. Password – Enter the password required to log on to the server.

Username – Enter the username required to log on to the server. NTRIP Caster HTTP:// – The address and port of the NTRIP Caster that the receiver will connect to to receive correction data. The list is ordered with the closest at the top of the list and includes the distance from your current location in km. Get Base Name List – Use this button to obtain a list of available IBSS base stations for selection.Base Name – Enter the name of the base station you want as the source of your corrections if known or select from the list using the Get Base Name list button.TCC Password – Enter the TCC password provided by your Organization TCC administrator.TCC Device ID – The Device ID is generated by the receiver.TCC Organization – Enter your TCC Organization name.IBSS Mode – Checking this mode provides a simplified UI for IBSS

The status is not one of those listed above. The NTRIP Client is in the process of connecting to the NTRIP Caster. NTRIP error 604 returned from NTRIP Caster.

NTRIP error 602 returned from NTRIP Caster. NTRIP error 503 returned from NTRIP Caster. NTRIP error 401 returned from NTRIP Caster.Ĭonnection failed due to an Internet-related issue. NTRIP error 404 returned from NTRIP Caster. NTRIP Client is connected to a source of corrections and receiving data. Status – Indicates the current status of the NTRIP connection: Status NTRIP version 2 is supported in firmware version 4.14 and later.

Another NTRIP compliant correction source.

The Trimble Internet Base Station Service (IBSS).

This option allows correction data to be received securely from an NTRIP Caster. One of the following groups appears, depending on the option that you select in the drop-down list at the top of the page: Local Port# – Select the port number that is to be used and then click Add to create the configuration. UDP Mode – Select this check box to use UDP (User Datagram Protocol) instead of TCP. Select this option to add a new TCP/IP port to the receiver. One of the following output groups appears with configuration settings, depending on the option that you select in the drop-down list at the top of the page:

Output Type – The second drop-down list displays which output type is sent out of each port.Port – The first drop-down list displays which type of port is available for configuration.By default, it is set to 60 seconds.Īuthenticate, set password – Select this check box so that all incoming connections are required to enter a password to authenticate the connection. If this is not enabled, remotes can reconfigure the receiver. Trimble strongly recommends this setting for all ports without a two-way data requirement. The remotes are unable to send data back to the receiver. Output Only/ Allow Multiple TCP/IP Connections – Select this check box to configure the receiver so that it can broadcast to multiple simultaneous remotes. This can be used when the receiver is behind a network firewall or has a dynamic IP address. This enables the receiver to initiate a connection to the remote server. However, you can change them and add or remove other ports.Ĭlient – Select this check box to enter a Remote IP and port. Use these settings to set up the receiver inputs and outputs.īy default, these ports are available. Receiver Web Interface > I/O Configuration menu > Port Configuration I/O Configuration (Port Configuration)